Equalizer® Talon™ Depth Control Oscillating Blades control how deep your oscillating tool cuts. Scratching the pinchweld on the outside when cutting from inside the vehicle has always been a problem with oscillating tools. Previously, there was no way to control how deep the blade would cut. Equalizer® Talon™ blades solve this problem. Each blade is formed in such a way that the vertical part of the bend will ride against the urethane and not go through it. These blades will fit the Falcon, Raven, and TimeSaver tools as well as most oscillating tools on the market. Will not fit the Ninja™ line of tools.
Made in the USA.
Customers who bought this item also bought
IS742
The most used tool by Auto Glass Technicians. Can be used to manipulate the urethane, remove door panels, install rubber gaskets, remove mouldings, lift the cowling, and tuck in headliners. Use the rounded tip for all the things you now use a regular installation stick for, and then turn it around and use the chisel-end to scrape excess urethane buildup out of corners where a pinchweld scraper or blade will damage the paint. They are great for removing excess wet urethane. Made in the USA.
TRI78
Triangular-shaped wire with sharp edges to cut through tough urethane.
UTO539
Used for puncturing the front seal and removing the rear seal...
