MDP181 • BounceBACK™ Pinchweld Protection System

Protecting the pinchweld when removing the glass has always been a problem for technicians. When a protector was placed between the glass and pinchweld the repeated hits by a power tool blade would cause that protector to jump out of the pinchweld, leaving the paint exposed to potential harm and tape would work to some extent, but would not hold sufficient downward pressure to keep the pinchweld protector in place. After extended use, the coating on the pinchweld protectors can become worn. When this happens you can remove the old coating and replace it with a fresh coating of impact absorbing tape. Each roll is 2” wide and 180’ long.