Products

This sharpening stone is designed to keep your hand away from the item being sharpened. Great for sharpening Equalizer® Blades, cold knife blades, or any other blade you want to put a razor-sharp edge-on.

Our Diamond Files are made of monocrystalline diamonds and their strong, single-crystal structure does not break apart with use. If you want to use a lubricant, use only water. To clean them just scrub with a bristle brush and dishwashing soap. The red file is fine and will put a razor edge on your cutting tools. The total length is 7" long and the file area measures 2-1/2" long which takes up very little room in your toolbox.

Our Diamond Files are made of monocrystalline diamonds and their strong, single-crystal structure does not break apart with use. If you want to use a lubricant, use only water. To clean them just scrub with a bristle brush and dishwashing soap. The blue file is coarse and will sharpen blades like a normal file. The total length is 7" long and the file area measures 2-1/2" long which takes up very little room in your toolbox.

Using our lubricant improves cutting action and reduces drag on the blade. Made in the USA.

BMW NAGS FW574/614

Replacement Vacuum Cup for Equalizer® Ricochet™ Pinchweld Protection System (PHV859) or Equalizer® BounceBACK™ Pinchweld Protection System (MDP181).

Volvo. NAGS FW398/404

Volvo NAGS FW398/404

Honda • Acura NAGS 2009-2016 • Honda Pilot and Odyssey • Acura ZDX and MDX

Ford F-150/250/350 NAGS DW1099

Honda NAGS FW2358, FW2387, FW2351

Protecting the pinchweld when removing the glass has always been a problem for technicians. When a protector was placed between the glass and pinchweld the repeated hits by a power tool blade would cause that protector to jump out of the pinchweld, leaving the paint exposed to potential harm and tape would work to some extent, but would not hold sufficient downward pressure to keep the pinchweld protector in place. After extended use, the coating on the pinchweld protectors can become worn. When this happens you can remove the old coating and replace it with a fresh coating of impact absorbing tape. Each roll is 2” wide and 180’ long.

Replacement 12" Pinchweld Protector for Equalizer® BounceBACK™ Pinchweld Protection System.

Replacement 18" Pinchweld Protector for Equalizer® BounceBACK™ Pinchweld Protection System.

Replacement 24" Pinchweld Protector for Equalizer® BounceBACK™ Pinchweld Protection System.