Products

Opens tight breaks to allow resin in...

Equalizer® Express™ Blades are developed for use on hundreds of different vehicles. The BFE1401 is the most widely used size and is perfect for slicing through wide bands of urethane. It works well in all areas where plunge cut or angle cut are used. This blade can also be used with our Express™ Blade Handle or PushKnife. Made of a proprietary grade of stainless steel. Made in the USA.

Equalizer® Express™ Blades are developed for use on hundreds of different vehicles. The LBE1403 blade is perfect for removing glass that is not broken. Its narrow width is more flexible, which puts less stress on the glass. This blade can also be used with our Express™ Blade Handle or PushKnife. Made of a proprietary grade of stainless steel. Made in the USA.

Equalizer® Express™ Blades are developed for use on hundreds of different vehicles. The BFE1400 is the most used size and is perfect for slicing through wide bands of urethane. It works well in all plcaes where you need to plunge cut or angle cut. This blade can also be used with our Express™ Blade Handle or PushKnife. Made of a proprietary grade of stainless steel. Made in the USA.

Equalizer® Express™ Blades are developed for use on hundreds of different vehicles. The LBE1402 work well where the urethane is far below the glass, but there is a limited amount of vertical space inside the vehicle. This blade can also be used with our Express™ Blade Handle or PushKnife. Made of a proprietary grade of stainless steel. Made in the USA.

Equalizer® Express™ Blades are developed for use on hundreds of different vehicles. The RLE1404 work well where the urethane is very deep below the dash. This blade can also be used with our Express™ Blade Handle or PushKnife. Made of a proprietary grade of stainless steel. Made in the USA.

For use in the DFG191 drill.

For use in RGD490 drill.

Hardened stainless steel probe...

Battery powered UV light...

for the VUV 1447...

12v with AC adapter...

Rechargeable LED UV Light...

Equalizer® HydroBlades™ have an array of microdots stamped into the surface of the blade that rides against the glass. These microdots are designed to flush cutting lubricant or water into the urethane that is being cut by the blade. With each stroke, the blade channels the lubricant from the outside of the urethane and flows it into the cut, allowing the blade to cut easily. This saves battery life and reduces vibration because of reduced friction. The HydroBlade™ is created from a proprietary grade of stainless steel and made in the USA. Designed to cut around very radical curves in the glass, and in vehicles that have corners with a sharper-than-90° angle.

for the KWR1491...